ESP01S (Upgraded ESP01S) ESP8266 Serial Wi-Fi Wireless Transceiver Module Board for Arduino

BHD5.50 inc. VAT

In stock

Connect your microcontrollers to the Internet of Things with the ESP-01S, the official upgraded revision of the classic ESP-01 ESP8266 Wi-Fi module. Operating on 3.3V DC, this compact 8-pin module features an upgraded 1MB Flash memory chip and optimized PCB layout with onboard pull-up resistors on essential boot pins (GPIO0, RST, CH_PD), eliminating the need for external breadboard resistors. Powered by the ESP8266EX chip, it delivers reliable 802.11 b/g/n wireless connectivity via simple Serial UART AT commands or custom firmware flashed through Arduino IDE, PlatformIO, or MicroPython. Perfect for smart home relays, remote environmental monitoring, and IoT prototyping.

ربط مشاريعك الإلكترونية بشبكة الإنترنت بكل سهولة مع موديول الواي فاي المطور ESP-01S المبني على شريحة ESP8266 الشهيرة. يمثل هذا الإصدار المحدث حلاً عتادياً متكاملاً يعمل بجهد 3.3 فولت، ويتميز بذاكرة فلاش مضاعفة بسعة 1 ميجابايت مع إضافة مقاومات سحب مدمجة (Pull-up Resistors) على دبابيس التشغيل الأساسية، مما يلغي الحاجة لإضافة مقاومات خارجية أثناء التوصيل. يدعم الموديول الاتصال اللاسلكي بمعيار 802.11 b/g/n عبر الأوامر التسلسلية (AT Commands) أو البرمجة المباشرة بواسطة بيئة أردوينو (Arduino IDE) ولغة MicroPython، مما ييجعله الخيار المثالي والركيزة الأساسية لتطوير أجهزة المنزل الذكي، المفاتيح اللاسلكية، والتحكم عن بُعد.

In stock

Description

  • Microcontroller / Wi-Fi Core: ESP8266EX SoC

  • Hardware Variant: ESP-01S (Upgraded 4MB Flash Revision)

  • Operating Voltage Range: 3.0V – 3.6V DC (3.3V Nominal, 5V Logic Incompatible without Level Shifter)

  • Flash Memory Size: 1 MByte / 8 Mbit SPI Flash Memory

  • Wireless Standard: 802.11 b/g/n (2.4 GHz)

  • Antenna Type: Onboard PCB Trace Antenna

  • GPIO Output Modification: Built-in pull-up resistors on GPIO0, RST, and CH_PD (No external pull-up resistors required for boot)

  • LED Status Indicators: Single Blue LED connected to GPIO2 (Tx/Rx Activity)

  • Header Pin Layout: 2×4 (8-Pin) 2.54mm Pitch Header Pins (VCC, GND, TX, RX, RST, CH_PD, GPIO0, GPIO2)

  • Interface Protocol: Standard AT Command Set via Serial UART

  • Baud Rate: 115200 bps (Default)

  • Application Suitability: Wireless IoT node creation, remote sensor data logging, smart home automation switches, and Arduino Wi-Fi expansion.

Go to Top